|
HSF-A MODEL TABLE: 1500W
|
MODEL(1)
|
OUTPUT VOLTS (V d-c)
|
ADJUSTMENT RANGE Front Panel Trimpot
(V d-c)
|
MAX OUTPUT CURRENT/POWER(2) (%)
|
OVERVOLTAGE PROTECTION (OVP)(3)
|
CURRENT LIMIT SETTING(4) (A d-c)
|
EFFICIENCY (typ.) (%)
|
RIPPLE/ NOISE(5) (mV p-p)
|
SENSE RESISTOR (IMON) (Ohms)
|
90-100V a-c Input(6)
|
100-264V a-c Input(7)
|
1500 WATT MODELS (Suffix A, AM)
|
HSF 15-100A, AM |
15 |
0-15.2 (0-16.6 (6)) |
90 - 100 |
105 |
120% ±7% of VSET |
105 |
86 |
180 |
0.001 |
HSF 24-50A, AM |
24 |
0 - 30.5 |
90 - 100 |
105 |
120% ±7% of VSET |
52.5 |
89 |
300 |
0.002 |
HSF 36-42A, AM |
36 |
0 - 36.8 |
90 - 100 |
105 |
120% ±7% of VSET |
43.7 |
89 |
360 |
0.002 |
HSF 48-32A, AM |
48 |
0 - 49.4 |
90 - 100 |
105 |
120% ±7% of VSET |
32.8 |
90 |
480 |
0.005 |
HSF 60-25A, AM |
60 |
0 - 62.0 |
90 - 100 |
105 |
120% ±7% of VSET |
26.2 |
91 |
600 |
0.005 |
(1) |
To specify digital front panel meter, add suffix "M" to model number, e.g., HSF 24-50AM.
|
(2) |
See output power vs temperature and input voltage ratings.
|
(3) |
Variable OVP at output terminals: 120% ±7% of VSET.
|
(4) |
Protection type: Latch-style (recovery after reset AC power ON or inhibit).
|
(5) |
Ripple and noise are measured at 20MHz of bandwidth by using a 12-inch twisted pair wire terminated with a 1 uF ceramic capacitor.
|
(6) |
16.6V at no load allows application with load wire voltage drop >0.75V per output wire. Load regulation will exceed published values (remote sense wire max compensation of 1V exceeded). May trigger OVP if local sense lines are enabled or load wire compensation is within rated 0.5V drop per output wire. If OVP occurs, adjust output to 15.2V max.
|
|