|
|
- If the status display shows SET, tap either the CURRENT or VOLTAGE control to take the unit out of setpoint mode (status display goes from SET to blank).
- Using a thin tool (e.g., a paper clip), press the FUNCTION switch once, then rotate either the VOLTAGE or CURRENT control until the status display reads CNFG.
- Tap DC OUTPUT switch to enter the submenu, then rotate either the VOLTAGE or CURRENT control until the status display reads VERS.
- The DC AMPERES display shows the firmware version.
- The DC VOLTS display identifies whether the firmware is the factory shipped firmware (Pri displayed) or field updated firmware (SEC displayed).
- If desired, view downloadable KLP Operator Manuals.
|
